![]() ![]() It is acceptable to restore 2017 rivets of 3/16 inch diameter or less, and 2024 rivets of 5/32 inch diameter or less with 2117 rivets for general repairs, pro vided the replacement rivets are 1/32 inch greater in diameter than the rivets they replace. Rivets might not be replaced by a type having lower strength properties, unless the low strength is adequately compensated by an increase in proportions or a greater amount of rivets. If the rivet hole becomes enlarged, deformed, or else damaged drill or ream the hole for the next larger size rivet. Replace rivets with those of the exact same size and strength whenever possible. These rivets can also be purchased in half sizes by designating a “0.5” after the main length. The universal head rivet (AN470) has been adopted as the standard for protruding-head rivets, and may be used as a replacement for the roundhead, flathead, and brazier head rivet. The 100-degree countersunk head has been adopted as the typical in the United States. The numbers are in series and each series represents a specific kind of head.Ĭountersunk head rivets are utilized the place where a smooth finish is desired. Each type of rivet is identified by a part number to permit an individual to choose the right rivet. The 2117-T rivet is designated as an “AD” rivet, and has a dimple on the head.Ī “B” designation is directed at a rivet of 5056 material and is marked with an elevated cross on the head. Two dashes on a head Aerospace rivets indicate a 2024-T alloy designated as a “DD” rivet. The 2017-T alloy rivet is designated as a “D” rivet and has a raised teat on the head. A rivet manufactured from 1100 material is designated being an “A” rivet, and has no head marking. AN-type aircraft solid rivets can be identified by code markings on the rivet heads. ![]() The 1100, 2017-T, 2024-T, 2117-T, and 5056 rivets would be the six grades usually available. ![]() The strength and temper conditions of aluminum alloy rivets are identified by digits and letters just like those used to spot sheet stock. The material employed for the majority of solid shank rivets is aluminum alloy. They are identified by the material of which they are made, the top type, size of shank, and temper condition. Solid shank rivets are employed widely during assembly and repair work. The two major types of rivets used in aircraft are the common solid shank rivets, which should be driven having an air-driven gun and bucking bar and special (blind) rivets, which are installed with special installation tools. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |